How To Refill Printer Ink

Hi Guys, on this auspicious occasion, admin re-share a post with label "How to" with the title:

HOW TO REFILL PRINTER INK

For Canon printer  iP> 1200/1300/1600/1700/1800/2200/2770/3680/4670 / MP> 150/170/237/258/276/450/496/558 / MG> 2170/2270/3170 / MX > 377/437/517 / E> 500/600 that uses cartridges PG> 40/50/810/830 / CL> 41/51/98/741/811/821/831 and similar.

1. Lift the hood of the printer so the cartridges run to the middle.
2. Once the cartridge truly silent, remove the cartridge by pressing the edge of the container, pulling up or pushing it down (depending on the type of printer).
3. After successfully issued cartridges, must let loose the sticker.
4. Plugs and widen it's hole with a needle  /a default pin of ink refill  to allow the ink injection needle can be entered.
5. Fill cartridges with ink  ± 5 cc (± ¼ bottle of black ink) and color ink ± 3 cc (± ¹ / з bottle (if really empty cartridges and cartridge is similar to 810/CL PG 811).
6. Wipe the ink that may be splattered around the hole and head of cartridges with paper towels so that the print-out was good.
7. Insert the cartridge into place and close the cartridge so that the container is locked again.
8. Close the hood of the printer as in a normal state.
9. Done.

After that try to print a sheet of the document and see the results. If the results are good means for filling the ink is right and of course because of the condition of the printer that is also normal. But if it was the printed result less / not good, probably a printer due to  problem as follows;

Findings Problems
1. The print-out striped.
2. The print-out just like spotting (the letters are cut off).
3. The printer will not print and the yellow light is flashing.

Solutions
1. To solve the number one problem, try to do "Cleaning" and so on. by the way> open a blank document or other one > click the Office Button (usually in the top left corner)> select Print> select Properties> select Maintenances > select Cleaning> select Execute> see the print-out is. If  it's still like before, try to "Deep Cleaning" ( below of Cleaning) and so on. If you still can not, try to clean it manually in case there is dirt / dust / ink cartridges trace especially around the sensor. If still can not, try to replace it with another cartridge.

2. To solve the second problem, try the cartridge head soaked into hot water for about 5 seconds (try to don't hit the sensor) , lift and dry it, then try installing again. If you still can not, try to pump the tank through the hole of cartridges refilling ink with empty bottles without injections needle . Then test ink the expenditure to paper towels and try to install it again. If it is still not ready, try the number one at last point way.

3. To solve the third problem, try to soak up spray cartridges into the hot water about 5 seconds (try to do not hit the sensor) , lift it and dry it, then try installing again. If it still does not, try to press the reset button for about 5 seconds and then undone and try again. If it still does not, try the number one at last point way.

That's sharing from admin for you, may be helpful. And to read and read sharing of admin with the title: how to diagnose printer, please click here. Okay, see you later. Insha Allah.